Rear Panel Parts Description - Sony TA-E1 Mode D'emploi

Rear Panel Parts Description

1 2 3
L
R
2 1
L I N E C D S A C D
1 LINE 1/2 input jacks
Connect to the analog audio output jacks of your
audio components (see page 7).
2 CD input jacks
Connect to the audio output jacks of your CD player
(see page 7).
3 SACD input jacks
Connect to the audio output jacks of your SACD
player (see page 7).
4 BALANCED LINE input jacks
Connect to the BALANCED OUT jacks of an audio
component that is capable of balanced output (XLR
type) (see page 7).
5 DIRECT input jacks
Connect to the analog audio output jacks of your
audio components. When a component is connected to
these jacks, pressing the DIRECT button to select the
component causes the indicator on the front panel to
light.
When the DIRECT button is pressed, the component
connected to these jacks takes priority over the
component selected with the INPUT SELECTOR
control.
12 GB
4 5 6
R L
OUT I N
B A L A N C E D L I N E DIRECT T A P E 2 / M D
7 8
L
R
R L
OUT I N
T A P E 1 / D A T PRE OUT B A L A N C E D O U T
6 TAPE 2/MD, TAPE 1/DAT IN/OUT jacks
Use to connect the input and output jacks of your DAT
deck, MD deck, tape player (etc.) (page 7).
7 PRE OUT jacks
Connect to your power amplifier(s) (see page 5).
8 BALANCED OUT jacks
Connect to your power amplifier(s) using balanced
cords (see page 6).
* : Displays the pin polarity of the BALANCED LINE jacks.
** : Displays the pin polarity of the BALANCED OUT jacks.
9 AC IN terminal
Connect the supplied power cord to the AC IN
terminal and then to the wall outlet to supply power
to the unit (see page 8).
9
*
CONNECTION
ASSIGNMENT
2 1
3
1 :GROUND
2 :HOT ( + )
3 :COLD ( – )
1 2
3
1 :GROUND
2 :HOT ( + )
3 :COLD ( – )
**