LEGRAND C2G31015 Mode D'emploi page 5

HDMI Ultra-Slim HDBaseT + RS232 And IR Over Cat Extender Box Receiver - 4k 60hz
Features
Supports HDMI 1.4 and HDCP 2.2 compatibility
•
Supports resolutions up to 4K@60 4:2:0 8bit
•
Via a Cat 6a/7 cable, transmits 4K@60Hz 4:2:0 8bit signal up to 40m/130ft and transmits
•
1080P signal up to 70m/230ft
Via a Cat 5e/6 cable, transmits 4K@60Hz 4:2:0 8bit signal up to 35m/115ft and transmits
•
1080P signal up to 60m/200ft
Supports bi-directional PoC
•
Supports bi-directional IR pass-through over HDBT
•
Supports bi-directional RS232 pass-through over HDBT
•
Supports CEC pass-through over HDBT
•
Supports firmware update
•
Slim profile, space saving and easy-to-install
•
Mounting Bracket Installation
Note:
Before installation, please ensure the unit is disconnected from the power source.
•
The height of installation should not exceed 2 meters from the ground.
•
Installation steps:
1. Remove the screws from one side panel of the unit.
2. Attach the installation bracket to the enclosure using the screws that were provided in the
package separately. The bracket height can be adjusted up/down or bracket face up or down.
3. The bracket is attached to the enclosure as shown.
4. Repeat steps 1-2 for the other side of the unit.
5. Attach the brackets to the surface you want to mount to using screws (not included).
Package Contents
•
•
•
•
•
•
•
•
3
1 x Receiver
1 x 18V DC Power Adapter with US, EU, UK
and AU Pins
1 x IR Emitter
1 x Broadband IR Receiver (30-50 KHz)
2 x Double sided tape for IR Emitter
and Receiver
1 x 3.5mm 3-Pin Phoenix Connector
2 x Mounting Bracket (with screws)
1 x Manual
(us) (us)
(us)