LEGRAND C2G31015 Mode D'emploi page 4

HDMI Ultra-Slim HDBaseT + RS232 And IR Over Cat Extender Box Receiver - 4k 60hz
Product Overview
Front Panel
① ② ③ ④
F P D
RONT ANEL ESCRIPTION
On: The device is powered on.
1 Power LED
Off: The device is powered off.
Blinking: The device is working properly.
2 Status LED
Off: The device is not working properly.
On: HDCP protected content is being transmitted.
Blinking: Non-HDCP protected content is being transmitted.
3 HDCP LED
This is normal and will not affect operation.
Off: No content is being transmitted.
On: HDBT link is normal.
4 Link LED
Off/Blinking: No HDBT link or link error.
RS232 DIP Switch for settings of RS232 function.
PASS THROUGH (default setting): RS232 port is
•
used for RS232 commands pass-through over HDBT.
5 Dip Switch
MCU: For MCU firmware update.
•
VS: For VS firmware update.
•
Note: Transmitter and receiver must be updated individually.
Receiver
⑤
Rear Panel
⑥ ⑦ ⑧
R P D
EAR ANEL ESCRIPTION
Locking power port, connect to the DC 18V power adapter provided.
Note: When the receiver is connected to a bi-directional PoC
6 DC 18V
enabled transmitter, only one power adapter is needed at
transmitter or receiver side to power both units.
7 HDBT IN Connect to the transmitter via a Cat 5e/6/6a/7 cable.
8 IR IN Connect to the IR receiver provided.
9 IR OUT Connect to the IR emitter provided.
For RS232 pass-through or firmware upgrade, and can be set
10 RS232
through DIP switch on front panel.
11 HDMI OUT Connect to an HDMI display using an HDMI cable.
2
Receiver
⑨ ⑩ ⑪
(us)
(us)