INVENTOR PM-WUI-16L Manuel D'utilisateur page 8

• If the dehumidifier is knocked over during use, turn off the unit and unplug it from the main power
supply immediately. Visually inspect the unit to ensure there is no damage. If you suspect the unit has
been damaged, contact a technician or customer service for assistance.
• In a thunderstorm, the power must be cut off to avoid damage to the machine due to lightning.
• To reduce the risk of fire or electric shock, do not use this fan with any solid-state speed control device.
• Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings. Do
not route cord under furniture or appliances. Arrange cord away from traffic area and where it will not
be tripped over.
• Do not open the unit during operation.
• When the air filter is to be removed, do not touch the metal parts of the unit.
• Do not operate the unit with damaged cord. Dispose the unit or return it to an authorized service facility
for proper checking and/or repair.
• Hold the plug by the head of the power plug when taking it out.
Electrical Information
l
• The manufactures nameplate is located on the rear or side panel of the unit and contains electrical and
other technical data specific to this unit.
• Be sure the unit is properly grounded. To minimize shock and fire hazards, proper grounding is
important. The power cord is equipped with a three-prong grounding plug for protection against shock
hazards.
• Your unit must be used in a properly grounded wall receptacle. If the wall receptacle you intend to use is
not adequately grounded or protected by a time delay fuse or circuit breaker(the fuse or circuit breaker
needed is determined by the maximum current of the unit. The maximum current is indicated on the
nameplate located on unit), have a qualified electrician install the proper receptacle.
• Ensure the receptacle is accessible after the unit installation.
• Do not use extension cords or an adapter plugs with this unit. However, if it is necessary to use an
extension cord, use an approved Dehumidifier extension cord only (available at most local hardware
stores).
• To avoid the possibility of personal injury, always disconnect the power supply to the unit, before
installing and/or servicing.
• All wirings must be performed strictly in accordance with the wiring diagram located on the middle
baffle of the unit (behind the water bucket).
Take note the fuse specifications
l
The unit s circuit board (PCB) is designed with a fuse to provide overcurrent protection. The specifications
of the fuse are printed on the circuit board, such as: T 3.15A/250V (or 350V), etc.
NOTE: All the pictures in the manual are for explanation purposes only. The actual shape of the unit you
.
purchased may be slightly different, but the operations and functions are the same
8
EN