INVENTOR PM-WUI-16L Manuel D'utilisateur page 19

• When unit is on, press the Timer button to activate the auto STOP function.
When the unit is off, press this button to activate the auto START function.
• Press the (+) or (-) button to change the time by 0.5 hour increments, up
to 10 hours or by 1 hour increments up to 24 hours. The control panel will
then count down time remaining until START or STOP.
• The time selected will be stored within 5 seconds and the main display will
automatically return to its previous state.
• When the auto START or auto STOP functions is set the Timer indicator is
lit identifying that ON or OFF timers are programmed.
• Turning the unit ON or OFF at any time or changing the timers setting to
0.0 will terminate the Auto Start/Stop function.
• When the control panel window displays code "P2", the Auto Start/Stop
function will be terminated.
NOTE: The timer function can either be set to ON or OFF. Setting
ON and OFF simultaneously is not possible.
MODE
By pressing the "MODE" button, various operations may be selected (Dryer, Cont., Smart).
While changing operation modes, device will make a short beep.
Manual Dehumidification (Set): Press the mode button until the manual setting of the
dehumidifier is selected. A light indicator marked ''Set'' will be activated on the control panel. Use
the humidity set buttons, as described below to select the ideal levels for your needs.
Cont.
Continuous mode: the dehumidifier operates continuously when the drainage pipe is attached,
or until the water tank is full, extracting humidity from the air. When this function is active the
indicator will turn on and the device will work constantly, disregarding the relative humidity
of the room and the desired humidity level set.
• For special humidity conditions where big amounts of condensation need to be
extracted, such as extremely moist rooms.
Smart
Smart Dehumidification – The dehumidifier will set the humidity level between 45% to 55%
according to the room's temperature thus ensuring energy efficiency and excellent room
conditions.
• While operating in this mode the manual humidity settings function is unavailable.
EN
19