DeWalt DW0165N Mode D'emploi page 13

Changing the Unit of Measure
By default, the tool will display measurements
in inches (74 9/16 in). You can change the unit
of measure to fractional ft (6'02"9/16), meters
(1.8940 m), decimal ft (6.21 ft), or decimal
inches (3.21 in).
On the first screen (Figure
1.
to display the Main Menu.
On the Main Menu (Figure
2.
and press
On the Settings Menu (Figure
3.
ft/m and press
Select the unit of measure.
4.
• 0'00" 0/00
• 0" 0/00
• 0'00" ft
• 0.00 in
• 0.0000 m
Press to save your setting.
5.
Choosing the Tool Position
By default, distances are measured from the
bottom of the tool to a wall or object (Figure
). To measure distances from a different
F 3
tool location, follow these steps.
On the first screen (Figure
1.
to display the Main Menu.
On the Main Menu (Figure
2.
and press
Select the tool position.
3.
• To measure from the top of the tool
(Figure ), select
F 1
• To measure from the tripod connection
on the tool (Figure
ft/m
), press
E 1
), select
E 2
.
), select
G
.
), press
E 1
), select
E 2
.
.
), select .
F 2
• To measure from a corner or another
hard-to-reach location with the endpiece
flipped open (Figure
) to measure from the end
(Figure
F 4
of the endpiece.
Press to save your new setting.
4.
Taking Measurements
Measuring Distance
Point the tool's laser (Figure
1.
a wall or object, and not toward anyone's
eyes.
Press (Figure
2.
on and display the red laser dot.
Make sure the tool position setting
3.
(Figure ) is correct for taking the
C 4
measurement.
Point the tool's laser (Figure
4.
the wall or object whose distance you need
to measure (Figure
Press to measure the distance from
5.
the tool to the wall or object.
At the bottom of the screen, view the
6.
current measurement (Figure
To take a new measurement, press
to move the current measurement up to the
previous line on the screen. Then repeat
steps 4-6.
Adding 2 Measurements
You can add two measurements to get a total
measurement of the two distances (Figure
Point the tool's laser (Figure
1.
a wall or object, and not toward anyone's
eyes.
), select
D 1
) toward
A 1
) to turn the tool
A 3
) toward
A 1
).
H 1
).
H 2
I
) toward
A 1
E
).
13