DeWalt DW0165N Mode D'emploi page 12

Loading Batteries
E
Pull up the endpiece on the back of the
1.
tool (Figure
Pull up the battery compartment latch on
2.
the back of the tool (Figure
).
D 3
Insert three AAA batteries, making sure to
3.
position the - and + ends of each battery
as noted inside the battery compartment
(Figure
D 4
Push the battery door down until it snaps
4.
in place (Figure
When the tool is ON, the battery level appears
on the screen (Figure
Turning the Tool On
Point the tool's laser (Figure
1.
a wall or object, and not toward anyone's
eyes.
Press
2.
on and display the red laser dot.
Choosing the Settings
Setting Automatic Turn Off
By default, the tool will automatically turn off
90 seconds after no buttons or options have
been selected. To change when the tool
automatically turns off, follow these steps.
On the first screen (Figure
1.
to display the Main Menu.
On the Main Menu (Figure
2.
and press
On the Settings Menu (Figure
3.
and press
12
).
D 1
D 2
).
).
D 5
).
C 1
A 1
(Figure ) to turn the tool
A 3
), press
E 1
), select
E 2
.
), select
G
.
Select the time.
4.
• Choose to turn off the tool after 30 sec,
60 secs, 90 secs, or 300 secs.
• To keep the tool turned on until you
manually turn it off (by pressing and
and
holding
Press
5.
Setting Screen Brightness
By default, the tool's screen will be set at 25%
brightness. To change the brightness level,
follow these steps.
On the first screen (Figure
1.
to display the Main Menu.
On the Main Menu (Figure
2.
and press
On the Settings Menu (Figure
3.
and press
) toward
Select the desired brightness level: 25%,
4.
50%, 75%, or 100%.
Press
5.
Turning Off the Sound
By default, the tool will beep each time you
take a measurement. You can turn off the
beeps.
On the first screen (Figure
1.
to display the Main Menu.
On the Main Menu (Figure
2.
and press
On the Settings Menu (Figure
3.
and press
Press
4.
for 10 seconds), select
to save your setting.
), press
E 1
), select
E 2
.
), select
G
.
to save your new setting.
), press
E 1
), select
E 2
.
), select
G
to display
to save your setting.
∞
.
.