Publicité
Les langues disponibles
Les langues disponibles
TROUBLESHOOTING
PROBLEM
Workpiece contact does not depress
fully - tool does not operate
Tool operates properly, but nails do not
drive fully
Tool operates properly, but nails are
driven too deep
Tool jams frequently
Tool stops and LED flashes rapidly
Tool has charged battery and LED is
slowly flashing or LED does not turn
off after approximately ten seconds of
non-use
NOTE: MAINTENANCE INFORMATION BEGINS ON PAGE 12 AFTER FRENCH
AND SPANISH LANGUAGE SECTIONS. ILLUSTRATIONS START ON PAGE 13.
These products have a 90-Day Satisfaction Guarantee Policy, as well as
a Three-year Limited Warranty. For Warranty and Policy details,
please go to powertools.ridgid.com or call (toll free) 1-866-539-1710.
POSSIBLE CAUSE
Low nails
Work-contacting element is jammed
Drive power is too low
Depth of drive isn't deep enough
Nail is too long for wood hardness
Drive power is too high
Depth of drive is too deep
Incorrect nails
Damaged nails
Loose magazine
Dirty magazine
Battery is low or has no charge
Trigger released too early
Tool has malfunctioned
11 - English
SOLUTION
Remove battery and replenish nails
Remove battery and clear jam
Increase power
Adjust depth of drive
Use nail length that is appropriate for
wood
Decrease drive power
Adjust depth of drive
Verify that nails are the correct size
Replace nails
Tighten screws
Clean magazine
Recharge battery
Remove battery and reinstall.
Take tool to nearest authorized repair
center
Publicité
