Hilti NCT IS 045-A22 Mode D'emploi Original page 9

3 Description
3.1 Product overview
3.2 Intended use
The product described is a cordless (battery-powered) electro-hydraulic cutting tool.
It is designed for cutting through cables made of copper (Cu), aluminum (Al) and steel (e.g. ACSR).
Before use of the power tool, all live cables or other items carrying electric voltage within the area in which
the user is working must be switched off. If this is not possible, the corresponding safety precautions for
working in the proximity of live cables or equipment must be implemented and observed.
▶ Use only Hilti lithium­ion batteries of the B 22 series with this product.
▶ Use only Hilti battery chargers of the C4/36 series for charging these batteries.
3.3 Possible misuse
• Do not use this hand-held product clamped in a fixed position or as a stationary device.
• Do not use the product in heavy rain or under water.
3.4 Charge status display
The charge status of the Li­ion battery is displayed after pressing the release button.
Status
4 LEDs light.
3 LEDs light.
2 LEDs light.
1 LED lights.
1 LED flashes, the power tool is ready for use.
Battery charge status cannot be displayed while the control switch is pressed.
3.5 Items supplied
Cutting tool, operating instructions
Other system products approved for use with this product can be found at your local Hilti Store or at:
www.hilti.group
4 Technical data
Rated voltage
Weight in accordance with EPTA Procedure 01
Max. cable diameter
max. cutting capacity for steel-reinforced aluminum cable (ACSR):
1590 MCM (Falcon)
*2258525*
1
2258525
Cutting head
@
Manual piston return switch
;
Casing
=
Servicing and fault indicator (red LED)
%
Battery release button
&
Battery
(
Slot on both sides to fasten the Hilti retaining
)
strap
White LED to illuminate the working area
+
Control switch
§
Meaning
Charge status: 75 % to 100 %
Charge status: 50 % to 75 %
Charge status: 25 % to 50 %
Charge status: 10 % to 25 %
Charge status: < 10 %
21.6 V
4.0 kg
45 mm
44.4 mm
(1 3/4 in)
English 5