emerio AC-125507 Mode D'emploi page 7

BEFORE USE
1. Pull the appliance out from the carton and place it on a solid heat-resistant horizontal surface.
2. Check if the accessories are complete including: four ice boxes, two wheels with brake and two wheels
without brake.
3. Insert four wheels into the corner holes and ensure the wheels are assembled tightly. Make sure the two
wheels with brake are assembled at the front side of the appliance. (If you need to lock the wheels, just
press down the brake lever.)
HOW TO USE
1. Turn the water tank lock to the horizontal position. Pull out the water tank slowly to leave 1/3 of the water
tank in the appliance body. Add water into the water tank. If you need the air sent out much cooler, put
the ice boxes (add water and freeze first) into the water. Make sure the water level is between the MIN
and MAX line. Check the water level from the water level window in the front side of the appliance.
Important! Use of the ice boxes:
Add water into the ice boxes; do not exceed the MAX line on the ice box when adding water into it. Screw
the cap tightly to make sure there is no leakage of water droplet. Keep the ice boxes away from children to
prevent ingestion. Freeze the ice boxes by placing them horizontally instead of standing vertically in the
freezer to avoid deformation.
Warning: the water level of the water tank must be less than "MAX" after the ice boxes are put into the
water tank.
2. Plug the appliance into the appropriate power outlet.
3. Turn on the appliance by pressing the wind speed buttons directly.
"Low" = low wind speed; "Mid" = medium wind speed; "High" = high wind speed.
4. Press the swing button to turn on the swing function. The air flow will swing left and right. Press the swing
button again to cancel the swing and fix the air flow at a specific direction horizontally. To adjust the air
flow direction vertically, just lift up or press down the louver outside.
5. Press the cooling button to turn on the cooling function. Press the button again to turn off the function.
This function is only effective when the water tank has ice box(es) inside. Do not activate this function
when the water in the water tank is below the "MIN" level; add enough water into the water tank first.
6. After use, press the cooling button and the swing button to position "OFF"; press the power off button and
unplug the appliance.
NOTES:
1. It is recommended to change water and clean water tank frequently.
2. Activating the cooling function with insufficient water may cause malfunction of the water pump inside the
water tank.
3. Do not take out the water tank immediately after the appliance is just turned off. Wait several minutes to
avoid the water dripping out from the cooling pad.
Water pump
- 6 -