Publicité
Les langues disponibles
Les langues disponibles
MAINTENANCE
Grease filters
Odor filters
EN 8
Saturation of the grease filters
After 30 operating hours, the exhaust setting and 'F' flash alternately on
the display. The grease filters must be cleaned.
Removing the grease filters
Pull the lever down and tilt the grease filter down.
Cleaning the grease filters
• Clean metal grease filters every 2 months or when the display
indicates this.
• Clean either by hand or in the dishwasher, which must be set to a
low temperature and a short cycle.
• The openings must be placed downwards to let the water run out of
the filters.
• When washed in a dishwasher, aluminium grease filters may be
discoloured slightly. This is normal and does not affect their filtering
capacity.
It is important that the grease filters are properly dried before
replacing them.
Reset the memory after replacing the grease filters. Switch on the
extractor hood and touch and hold the minus (-) key for 3 seconds
until "E" shows on the display. The extractor hood switches off.
Installing odor filters
Odor filters must always be used if the cooker hood is not ducted.
1. Remove the grease filters.
2. Attach the odor filters in the motor housing; position the tabs and
attach the holder with the odor filter.
3. Replace the grease filters.
The functioning:
• More noise is produced when odor filters are used than when the
cooker hood is used with an exhaust vent.
• Odor filters function optimally at a lower motor speed. For this
reason, avoid the intensive setting.
Publicité
