Publicité
Les langues disponibles
Les langues disponibles
3. Under Rail Bedliner Installation Steps
4. Over rail Bedliner Installation Steps
Page 2 of 7
(NOTE: Some bedliners may not have front rail lip. Details
B & C for rear fastener may not be on all models.)
STEP 1
Place bedliner in truck box. While standing beside truck at
approximately the center of box area, lift side of bedliner up at
a 450 angle so that the opposite side slips under the siderail
of pickup truck (See FIGURE 1). A second person may be
required to help slip the wall of the bedliner under the sidewall
of the truck box.
STEP 2
Stand at rear of pickup (center) and lift bedliner floor up. Have
a second person push bedliner wall under siderail of the
pickup truck (See FIGURE 2). Release bedliner floor.
STEP 3
Using a power screwdriver, center a self tapping screw in a
predrilled hole in the bedliner and fasten to the truck bed
sidewall.
Do not over tighten as screws can be stripped out.
STEP 4
Repeat STEP 3 to other side.
STEP 1
With the Bedliner Out Of Truck:
Assemble "Liner-Lok™" fasteners by sliding metal clip
1.
onto plastic swingnut (see FIGURE 1).
2.
Insert screw through hole provided in bedliner side wall,
with head of screw toward inside of truck bed.
Position "Liner-Lok™" fastener with side "A" towards
3.
screw tip (see FIGURE 2).
4.
Insert screw tip into hole and metal clip of fastener and
turn one or two rotations, or until tip of screw in engaged
into fastener.
IMPORTANT: The "Liner-Lok™" must be in a loose
downwardhanging position at this time. (see FIGURE 5)
Repeat "Liner-Lok™" fastener assembly to remaining
5.
holes.
STEP 2
Place bedliner with loosely hanging "Liner-Lok™"
fasteners into truckbox. Pull the bedliner rails away from
truck rails and push downward starting at front corner,
until forward "Liner-Loks™" slip under the truck rails.
Make certain that all "Liner-Lok™" fasteners have
slipped under the truck rails before tightening (see
FIGURES 3, 4 & 5).
STEP 3
Close tailgate. Adjust bedliner if needed.
STEP 4
Standing or kneeling on bedliner in truck box:
1.
Start at either front (cab end) corner and push
downward on bedliner rail while turning screw
clockwise with screw driver (see FIGURE 6). You
should "feel" the "Liner-Lok™" pivot upwards and
stop. Continue turning the screw clockwise until
tight (see FIGURE 7).
2.
Move to opposite corner and repeat step 4 - 1.
3.
Repeat step 4 - 1 to remaining "Liner-Loks™".
www.TrailFX.com
Rev 062816
Publicité
