Danby DAC12010E Mode D'emploi page 7

KEY PAD FEATURES
LED DISPLAY: Displays the following information
independently;Set Temperature, Ambient
RoomTemperature and Auto Timer On/Off settings.
POWER: Turns unit On/Off.
MODE: Allows you to scroll through and select
the desired operating mode; Cool , Dry , Fan Only
and *Auto .The selected mode will be denoted by the
adjacent indicator light.*'Auto'is a pre-set factory
program that automatically defines the mode (Cool or
Dry) and fan speed based on the set temperature
FAN SPEED: Select from four different fan
settings;Low , Medium , High and Auto during Cool
and Fan Only mode. Please note: During 'Dry' mode
the fan speed is automatically defined .
ENERGY SAVER: Automatically cycles the fan
on and off while the compressor is not in use.
TEMP / TIMER CONTROL: Used to
increase or decrease the Temperature setting in 1°C /
°F increments, and Auto-Timer On/Off
settings in 30min./1hr. increments. Note: This
appliance allows you select the temperature scale to
be displayed in either "Celsius" or Fahrenheit"
according to your preference.To change the
temperature scale displayed on the electronic display,
press both the "Temp/Timer"adjust arrows
simultaneously to alternate between
"Celsius"&"Fahrenheit".
CHECK FILTER: The adjacent indicator light
will illuminate as a reminder to clean the air
conditioner filter (see page 9) Once the filter has
been cleaned and replaced, depress the Check Filter
button in order to resume operation.
SLEEP MODE: When activated, the current set
temperature is gradually increased over a one (1) hour
period then maintained for seven (7) hours. Once the
program is complete, the air conditioner will resume
to its previous set temperature (before sleep mode was
activated). This feature is mean to be used during the
night time hours to prevent the room from getting too
cold (while you sleep) and results in less compressor
running time and reduced energy consumption. Sleep
mode may be cancelled by depressing the Sleep Mode
button while the program is running.
AUTO-TIMER: Used to initiate the Auto On/
Auto Off timer.
OPERATING INSTRUCTIONS
6
Temp/Timer
Control
Check
Filter
Mode
Selector
Energy
Saver
While the Air Conditioner is off (Auto-On):
1) Press the Auto-Timer button once and the adjacent
Auto-On indicator light will illuminate.
2) Use the Temp/Timer control cursors to select a
delayed On time of up to 24 hours.
3) Select the appropriate mode under which you want
the unit to operate (Auto-Cool-Dry-Fan Only)
4) Select the fan speed setting.
5) The time you selected will appear in the LED
display.
While the Air Conditioner is on (Auto-Off):
1) Press the Auto-Timer button twice and the adjacent
Auto-Off indicator light will illuminate.
2) Use the Temp/Timer control cursors to select a
delayed Off time of up to 24 hours.
3) The time you selected will appear in the LED
display. The Auto On and Auto Off timer can
operate during the same program by defining the
Auto-Off parameters immediately after the Auto On
parameters. The Auto-Timer may be cancelled at
any time by turning the unit On/Off.
LED
DISPLAY
Auto
Timer
Sleep
Mode
Fan
Speed
Power
Button