Makita CL104D Manuel D'instructions page 8

10. Do not use to pick up flammable or combustible
liquids, such as gasoline, or use in areas where
they may be present.
11. Use only the charger supplied by the
manufacturer to recharge.
12. Do not pick up anything that is burning or
smoking, such as cigarettes, matches, or hot
ashes.
13. Do not use without filters in place.
14. Do not charge the battery outdoors.
15. This appliance is not intended for use by persons
(including children) with reduced physical,
sensory or mental capabilities, or lack of
experience and knowledge, unless they have been
given supervision or instruction concerning use
of the appliance by a person responsible for their
safety.
16. Children should be supervised to ensure that they
do not play with the appliance.
SAVE THESE INSTRUCTIONS.
This appliance is intended for household use.
ADDITIONAL SAFETY RULES
1. Read this instruction manual and the charger
instruction manual carefully before use.
2. Do not pick up the following materials:
- Hot materials such as lit cigarettes or spark/
metal dust generated by grinding/cutting metal
- Flammable materials such as gasoline, thinner,
benzine, kerosene or paint
- Explosive materials like nitroglycerin
- Ignitable materials such as Aluminum, zinc,
magnesium, titanium, phosphorus or celluloid
- Wet dirt, water, oil or the like
- Hard pieces with sharp edges, such as wood
chips, metals, stones, glasses, nails, pins or
razors
- Powder to clot such as cement or toner
- Conductive dust such as metal or carbon
- Fine particle like concrete dust
Such action may cause fire, injury and/or property
damage.
3. Stop operation immediately if you notice anything
abnormal.
4. If you drop or strike the cleaner, check it carefully
for cracks or damage before operation.
5. Do not charge the cleaner close to dangerous
flammable materials such as gasoline, gas, paint
or adhesives.
6. Do not charge the cleaner on papers, cloth, carpet,
vinyl, etc. This may cause a fire.
7. Do not charge the cleaner in a dusty place.
8. Be sure no one is below when using the cleaner in
high locations.
9. Do not bring close to stoves or other heat
sources.
10. Do not block the intake hole or vent holes.
8
SAVE THESE INSTRUCTIONS.
IMPORTANT SAFETY
INSTRUCTIONS
FOR BUILT-IN BATTERY
1. Before using built-in battery, read all instructions
and cautionary markings on (1) battery charger,
(2) battery, and (3) product using battery.
2. Do not disassemble built-in battery.
3. If operating time has become excessively shorter,
stop operating immediately. It may result in a risk
of overheating, possible burns and even an
explosion.
4. If electrolyte gets into your eyes, rinse them out
with clear water and seek medical attention right
away. It may result in loss of your eyesight.
5. Do not short the built-in battery:
(1) Do not touch the terminals with any
conductive material.
(2) Avoid storing built-in battery in a container
with other metal objects such as nails, coins,
etc.
(3) Do not expose built-in battery to water or
ENB106-3
rain.
A battery short can cause a large current
flow, overheating, possible burns and even a
breakdown.
6. Do not store the tool and built-in battery in
locations where the temperature may reach or
exceed 50°C (122°F).
7. Do not incinerate the built-in battery even if it is
severely damaged or is completely worn out. The
built-in battery can explode in a fire.
8. Be careful not to drop or strike battery.
SAVE THESE INSTRUCTIONS.
Tips for maintaining maximum battery life
1. Charge the built-in battery before completely
discharged.
Always stop tool operation and charge the built-in
battery when you notice less tool power.
2. Never recharge a fully charged built-in battery.
Overcharging shortens the battery service life.
3. Charge the built-in battery with room temperature
at 10°C - 40°C (50°F - 104°F). Let a hot built-in
battery cool down before charging it.
4. Charge the battery cartridge once in every six
months if you do not use it for a long period of
time.
FUNCTIONAL DESCRIPTION
CAUTION:
• Always be sure that the tool is switched off before
adjusting or checking function on the tool.
Charging the built-in battery
CAUTION:
• Do not operate the cleaner during charging. It may be
damaged.
ENC010-1