LENCO Classic Phono HOG075 Mode D'emploi page 9

Connecting the turntable to external speaker
In connecting the turntable to external speakers (via a suitable amplifier)
Use a twin phono to twin phono lead (not included) to connect the RCA output jacks to the Audio in of the
amplifier. Ensure red plugs are inserted into the red sockets and white into white.
Using with Bluetooth device
Check that your turntable is in Bluetooth mode. If you are not already in Bluetooth mode, short press the
Mode button until you are in Bluetooth mode (Blue LED will be illuminated). It will begin to search for
Bluetooth devices (Blue LED flashed during pairing).
In Bluetooth Mode:
1. Your device will search for Bluetooth.
2. On the device (e.g. iPhone/iPad/Android/other phone/Tablet/Computer), turn on Bluetooth connectivity
and ensure that it is 'discoverable'.
Note: If necessary, refer to the instructions for your device to add or set up Bluetooth.
3. Select to 'Add new device', if necessary.
Note: Some products will automatically search for a new device and so the 'Add new device' option is not
available.
4. When found, your device will be displayed as 'Lenco TT-110'. Select and begin pairing.
5. When pairing is complete 'Bluetooth Connected' will be displayed.
6. Now that you have paired your device with the turntable, it will connect to it when it is within range, which
is about 10 meter or less (33 feet or less), line of sight.
7. Your device will remain paired with the turntable unless you decide to disconnect or 'unpair' it.
8. You can short press "Pair" to reconnect.
Playing Bluetooth
1. Press "Back" for previous track of your Bluetooth device.
2. Press "Next" for next track of your Bluetooth device.
3. Press "Play/pause" for play or pause of your Bluetooth device.
"This product has a bluetooth reception function, you can not transmit any bluetooth sound with it:
this means that you can receive wirelessly a bluetooth sound signal from an external source like a
smartphone."
HOW TO REPLACE THE NEEDLE
To replace the needle, please refer to the instructions below.
Removing the needle from the cartridge
1. Place a screwdriver at the tip of the stylus and push downward as shown in direction "A".
2. Remove the stylus by pulling the stylus forward and pushing downward.
Installing the Stylus
1. Hold the tip of the stylus and insert the stylus by pressing as shown in direction "B".
9