Siemens LI 48630 Mode D'emploi Et Notice De Montage page 23

Operating the extractor hood
Switching off:
There are 2 different methods of switching
off the appliance whether in manual or
automatic mode.
Switching off directly:
L
Press the button.
Important: All fan functions are switched
off.
Switching off appliance with fan run-on:
Insert filter drawer all the way. The fans
operate in the last switched-on stage for
around another 10 minutes and then switch
off.
If the intensive setting is switched on
when the filter drawer is inserted, the
intensive setting automatically switches
back during run-on.
If intermittent ventilation is switched on, it
continues operating normally following
run-on.
Light
The light can be used at any time, even
when the appliance has been switched
off.
Switching on/off: Press the
Adjusting the brightness:
a
Hold down the button until the
desired brightness is obtained.
Special functions
Switching on the light automatically, e.g.
via a timer:
Switching on:
Simultaneously press the
buttons.
Switching off:
Repeat the process with the light switched
on.
Adjusting the sensitivity of the sensor
control:
1. Press and hold down the automatic
2. To display the current sensitivity, press
3. You can now change the sensitivity of
a
button.
Fan and light must be switched off.
After approx. 3 seconds the light
switches on to acknowledge the setting.
After approx. 3 seconds the light
switches off to acknowledge the setting.
button.
+ –
the or button.
the sensor control by pressing the
–
button.
@
Factory setting: .
{
Lowest setting: .
Ö
Highest setting: .
a
and
L
+
or
23