4-Channel Wiring
•
2/4 CHN. SWITCH
out to set to 4 CHN.
•
Gain (Front & Rear)
- is set independently to
suit application.
•
Crossover (Front &
Rear) - is set
independently to suit
application.
Stereo Bridged
O
PERATION
REMOTE PUNCH BASS
Mounting and installation
1.
Find a location that gives easy access to the remote.
NOTE:You can mount this unit in a variety of ways. Remove the back housing by using a small flat
screwdriver in the slotted hole at the back.The housing can be installed with the mounting tab up
or down, or left off for in panel installation.
2.
Route the cable for the remote and connect to the amplifier.
I
NSTALLATION
9