Publicité
Les langues disponibles
Les langues disponibles
Assemble the burner parts according to the illustration.
1.
1
2
3
4
Burner cap
1
Burner base
2
Thermocouple
3
Igniter
4
Make sure that the prongs of the burner cap fit snugly
into the groove of the burner base.
Check to make sure that there is no gap between the
2.
burner parts. You may gently try to move the burner
parts from side to side to check if they are properly
seated.
4.8 Installing the burner grates
WARNING
Improperly positioned grates can cause flare-ups.
Position all grates properly on the cooktop whenever
▶
the cooktop is in use to properly support pots and avoid
spills.
Make sure each of the four feet of the grates is placed
▶
into the corresponding dimples on the cooktop surface.
Do not use a grate if the rubber feet are missing or
▶
damaged.
4.9 Checking the installation
Check if your unit is working properly after you have
completed the installation steps.
WARNING
Before you turn on power supply, make sure all controls
are in the OFF position.
Ensure that the burner caps are properly positioned.
1.
Turn each burner on in turn and verify that the electric
2.
igniters are working.
Push down the control knob and turn it counter-
‒
clockwise to the ignition symbol .
Verify that the igniter/spark module clicks.
‒
Once the air has been purged from the supply lines,
‒
verify that the burner lights within 4 seconds.
When the burner lights, turn the control knob back to
‒
the off position.
If any of the burners do not ignite, do not continue
‒
testing. Call Customer Service.
Turn the control knob between the highest and lowest
3.
setting. Make sure the flame does not go out and there
are no flashbacks.
If you have carried out an LP gas conversion, check the
4.
lowest setting to confirm the flames are stable on the
ports and the set screws do not need to be readjusted.
Check the flame characteristics.
5.
The flame should be blue with a minimal yellow tip on
the outer cone.
After completing all checks, complete the installation of
6.
the horizontal panel or oven. → Page 9
Note: The appliance is shipped from the factory for use
with natural gas. If you want to use propane gas, it must
be converted. A qualified technician or installer must do
the conversion. Refer to Conversion to LP gas.
Installation procedure en-us
13
Publicité
