Vonyx AV510 Manuel D'instructions page 4

UNPACKING INSTRUCTION
CAUTION! Immediately upon receiving of the equipment, carefully unpack the carton, check the contents to ensure that all parts
are present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection
if any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing
materials. In the event that an equipment must be returned to the factory, it is important that the equipment be returned in the
original factory box and packing.
If the equipment has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately.
The arising condensation water might damage your device. Leave the device switched off until it has reached room
temperature.
FRONT PANEL
1. POWER ON/OFF
Press to turn on/off the device.
2. MUSIC VOLUME CONTROL
Turn to control the music volume.
3. ECHO EFFECT
Turn to adjust the echo effect for both
microphones.
4. TONE CONTROL
Turn to adjust the tone for both microphones.
5. MICROPHONE A VOLUME CONTROL
Turn to control the volume level of microphone A.
The LED lights of this knob will light up when
microphone A is connected successfully with the
AV510 controller.
6. MICROPHONE B VOLUME CONTROL
Turn to control the volume level of microphone B.
The LED lights of this knob will light up when microphone B is connected successfully with the AV510 controller.
7. IR & LED LIGHT CLUSTER
IR - Infrared receiver for remote control
COAXIAL - LED will light up when coaxial signal is detected
OPTICAL - LED will light up when optical signal is detected
BT - LED will light up when BT connection has been successful
LINE - LED will light up when LINE signal is detected
REAR PANEL
1. AUXILIARY OUTPUT
3.5mm stereo jack output. Use to connect
with, for example, an amplifier or a computer.
2. AUXILIARY INPUT
3.5mm stereo jack input allowing you to
connect various external audio devices.
3. OPTICAL INPUT
Optical input terminal allowing you to connect
to TV, set-top box, etc.
4. COAXIAL INPUT
Coaxial input terminal allowing you to connect to TV, set-top box, etc.
5. DC 5V IN
5V adapter input.
OPERATION
1. Connect the AV510 controller to a power outlet via the supplied power adapter.
Check and make sure that the mains voltage corresponds with the supplied adapter. By using any other voltages than
specified, the equipment can be irreparably damaged. Do not use a dimmer or adjustable power supply.
2. Put two alkaline AA batteries in the battery compartment of the microphone(s). Make sure that the positive and negative
poles are corresponding with the markings within the compartment.
3. Slide the ON/OFF switch of the microphone(s) in the ON position. The microphone(s) will connect with the receiver
automatically, the LEDS on the knob of the corresponding microphone channel will light up.
4