Publicité
Les langues disponibles
Les langues disponibles
A
RADIO OPERATION
1
Press RADIO BAND * repeatedly to select
the desired band.
The power is turned on and the previously tuned
station is received.
* or BAND on the remote control (applicable
when the AC cord is connected, CSD-TD59
only)
2
Press f , g (TUNING -, +) to select
a station.
During FM stereo reception,
After listening, press POWER 6 STANDBY/ON to
turn the power off.
For better reception
FM
Extend the rod antenna
and orient it for the best
reception.
For quick tuning (Auto Search)
Keep f, g pressed until the tuner starts
searching for a station. When a station is tuned to, the
search stops.
If the broadcast signal is weak, it does not stop. To
stop the search manually, press f or g.
To listen with the headphones
Connect headphones with a stereo mini plug to the
\ PHONES jack on the rear of the unit.
6
ENGLISH
FM
AM
is displayed.
AM
The antenna is inside the
unit. Position the unit for
the best reception.
REPEAT/MODE/SLEEP *
- If an FM stereo broadcast contains noise, press the
button so that
is displayed.
Noise is reduced, although reception is monaural.
To restore stereo reception, press the button again.
- If a high-pitched sound is heard during AM recording,
press the button repeatedly to display "b1" or "b2", so
as to eliminate the noise.
* or MODE on the remote control (CSD-TD59 only)
To change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/
step. If you use the unit in an area where the frequency
allocation system is 9 kHz/step, change the interval as
follows.
1 Press RADIO BAND.
2 Press POWER 6 STANDBY/ON while pressing
RADIO BAND.
When the AM tuning interval is changed, the preset
stations are cleared.
NOTE
If the unit picks up noise from other electrical
appliances nearby, like a TV or fluorescent lights, move
the unit.
Publicité
