CLAS B.LINE OP 1522BL Mode D'emploi page 11

OP 1522BL
- Use appropriate pneumatic oil. Use only recommended lubricants, specially designed for
pneumatic applications. Substitutes can damage rubber compounds in tools and other
rubber parts.
Important!!!!!
If a fi lter/regulator/lubricator is not installed on the air system, the pneumatic tools must be
lubricated at least once a day or after 2 working hours with 2 to 6 drops of oil, depending
on the working environment, directly through the male coupling.
OPERATING INSTRUCTIONS
Attention! Be sure to read, understand and follow the safety instructions before use.
1. Remove the protective cap (Fig 1)
2. Screw the connection by hand (Fig 2) after applying Tefl on
3. Add 2-3 drops of oil to the fi tting (Fig 3)
4. Connect to the air source (Fig 4)
5. Mount your socket (Fig 5)
1/2" D. IMPACT WRENCH 1600Nm DOUBLE HAMMER