MPM MOP-49M Mode D'emploi page 15

3. Before using for the first time, the hot plates must be properly conditioned by running them
hot. Place the appliance on a firm, dry, level and smooth surface, plug the power cord to the
mains. Leave it running for 10 minutes. Next, unplug the appliance from the mains and wait
until it cools down completely. The hot plates may smoke slightly during this process. This is
natural and will no recur during further use. Wipe the hot plates with a damp cloth and wipe
them dry.
NOTE! Bread may burn! Therefore the appliance must not be used near or below curtains and in vicinity of other
combustible materials!
NOTE! The working surfaces of the roaster are heated up to extremely high temperatures! Touch the holders
only!
USE OF THE ROASTER
NOTE! When opening the cover, proceed carefully owing to hot damp from the area under the heating panels!
1. Oil the heating plates ❺ with butter, margarine or other fat.
2. Insert the plug into the socket – red caution lamp (power supply) ❶ and green caution lamp
(thermostat) ❷ will go on. Close the cover of the appliance ❸.
3. Prepare the sandwiches.
4. When the green indicator lamp ❷ will go off, open the cover by pulling the latch ❹ and put
the sandwiches on the heating panels. Gently close the cover and clamp with clip ❹.
5. When checking the condition of sandwiches in course of their roasting, open the cover care-
fully owing to hot damp escaping from the both sides of the roaster!
6. Open the cover and remove roasted sandwiches using wooden or plastic spatula.
7. Before preparation of the next sandwiches, always close the cover in order to maintain re-
quired temperature. The green caution lamp (thermostat) will go on and off in course of
roasting to indicate that required temperature is maintained.
8. After finished roasting pull out the plug from the plug socket and allow the appliance to cool
completely.
NOTE! Do not use and metal and sharp knifes or forks, otherwise the damages of heating surfaces are possible!
CLEANING AND MAINTENANCE
1. Prior to commencing the cleaning (and after finishing the roasting), pull out the plug from
the plug socket and allow the appliance to cool completely.
2. Thoroughly wipe the heating panels, clean the roaster edges using soft cloth or towel.
3. If complete removal of any food residuals from the surface of heating panels is problematic,
pour some edible onto dirty surface and try to clean after about 5 minutes. Your efforts will
be successful this time.
4. Wipe the external surface of the roaster using wet cloth.
ATTENTION! Do not immerse the appliance in water or any other liquids! Do not wipe the inside of the appliance
with acute, abrasive cloths or sponges, as this can damage the heating surfaces!
15