Publicité
Les langues disponibles
Les langues disponibles
6 Adjusting the Image
To ensure the best image quality, follow the steps below to adjust the projected image.
Do not make adjustments with the Quick Corner or Keystone functions of the
projector. Doing so may result in a reduction in image quality and pen or finger touch
calibration.
Follow these guidelines for setting up the projector:
•
Make sure the image is evenly rectangular, without distortion.
•
Make sure the projector is tilted no more than 3° vertically and horizontally in relation to the projected
image.
Your remote control or projector control panel may look different from the
illustrations in this section, but the instructions are the same except where noted.
A
Turn on the projector
B
Change the aspect ratio if necessary
Each time you press the [Aspect] button on the remote control, the aspect name is displayed on the
screen and the aspect ratio changes. You will need to re-display the test pattern after changing the
aspect ratio.
Change the setting according to the signal for the connected equipment.
You will need to project content from a connected device in order to change the aspect
ratio.
Alternatively, set the aspect ratio from the Signal menu - Aspect. Following is a list of available aspect
settings:
BrightLink 480i and PowerLite 470/480/570/580/680
•
Auto: Automatically sets the aspect ratio according to the input signal and the Resolution setting
(available only for HDMI image sources).
Remote Control
Remote Control
35
Control Panel
Aspect Ratio
Normal
Publicité
