Publicité
Les langues disponibles
Les langues disponibles
F
Adjust the vertical slide position of the arm
1. Adjust the vertical slide with the M8 hexagon bolt at the bottom of the wall mount (
hexagonal shaft at the top of the wall mount (
alignment mark on the wall plate as shown below.
Tightening the M8 hexagon bolt lowers the wall mount, and loosening the bolt raises it (
Tightening the hexagonal shaft raises the wall mount, and loosening the shaft lowers it (
2. Tighten the M6 × 20 mm hexagon shoulder bolt to secure the wall mount.
). Start by aligning the notch on the arm with the
32
), or the
).
).
Alignment marks
Publicité
