Error Message - Husqvarna PP 455 E Manuel D'utilisation

Error message (7)

'No contact Check the CAN cable"
Cause (7)
In remote controls fitted with a radio and a battery, this
warning is displayed if the incoming voltage to the power pack
disappears.
The CAN cable, or its connector is damaged, which results in
the hydraulic unit not being possible to control via the remote
control.
Action (7)
Press OK to acknowledge the error message. Check the
cable and connector and replace if damaged. Contact the
service personnel if the fault remains.
Error message (8) - applies to units
equipped with a radio system
'No radio contact"
Cause (8)
The radio contact between the hydraulic unit and remote
control is not working.
Action (8)
Several actions may be necessary to rectify the fault:
• Ensure (via the operations menu - settings - radio id) that
the identity number is greater than 0.
• Make sure that the hydraulic unit has been started.
• Move closer to the hydraulic unit to prevent long distances
or reinforced walls.
20 –
English
MAINTENANCE