Start Menu; Operations Menu - Husqvarna PP 455 E Manuel D'utilisation

Start menu

The start menu is shown each time the power to the hydraulic
unit is switched on.
SELECT FUSE
The fuse rating must be set according to the fuse the hydraulic
unit is connected to. Select one of the following options:
• 32A
• 63A
• Press OK to confirm the selection.
SELECT POWER
The hydraulic output must be set depending on the machine
connected to the hydraulic unit. Select one of the following
options:
• 25 kW, 230 bar, 65 l/min (3300 psi, 17 US gpm)
• 9 kW, 140 bar, 40 l/min (2000 psi, 10 US gpm)
• Press OK to confirm the selection.
CONNECT HOSES
In this position, connect the hydraulic hoses. A pressure
equalizing function making it easier to connect the hoses is
now activated. This spares the seals in the hydraulic
couplings.
• Press OK when all hoses are connected.

Operations menu

All information about operations and all setting options are
accessed from this menu.
START MOTOR
• Press the green button on the remote control to start the
electric motor.
STATUS
Status is the main information that is always shown on the
display when the hydraulic unit with connected machine is
operational.
• OK, signifies that the unit is operational and no warning
messages have been issued.
• CW xx, where CW represents water coolant and xx ON or
OFF. What is shown depends on whether the water
coolant is switched on or off.
• yyy BAR, where yyy represents the instantaneous
operating pressure.
• When time is switched on: mm:ss, is also shown, i.e. the
time in minutes and seconds.
COOLING WATER
Turn on (ON) or turn off (AUTO) the cooling water by pressing
OK.
The current water coolant temperature is shown i the display.
MENU SYSTEM
PHASE 1, 2, 3
The instantaneous main voltage to the hydraulic unit is shown
under each phase name.
When the voltage becomes low, an error message is shown
on the display, see the section 'Error messages".
NOTICE! Long electrical cables with a small core cross
section can result in a voltage drop. The hydraulic unit can
then warn of a too low voltage.
MACHINE TIME
State the total time that the blade/wire rotates for the
connected power unit.
ID POWER PACK
State the hydraulic unit's machine number.
BATTERY
This function checks the remote control's battery. Different
messages are shown on the display, depending what is
currently happening with the battery:
• CHARGING BATTERY - The CAN cable is connected and
the battery is charging.
• BATTERY FULL - The battery is fully charged.
• 0% BATTERY 100% - The bar shows the battery status.
• NO BATT. CONNECT - No battery can be detected.
SETTINGS
All Setting options for the hydraulic unit and the remote control
are accessed via this sub-menu.
SET LANGUAGE
To select the language:
• Scroll using the arrow keys until the required language is
shown.
• Press OK to confirm the selection.
STOP WATCH
The function is used to measure the amount of time a job
takes. The time is counted from when the saw starts working.
Select:
• ON, to enable.
• OFF, to disable.
• RESET STOP WATCH, to reset.
Browse with the arrow keys and confirm with "OK".
– 13
English