Checking The Battery Charge; Attaching / Removing The Holding Bracket; Installing / Replacing The Saw Blade; Start-Up - FLORABEST FAAS 10.8 A2 Instructions D'utilisation Et Consignes De Sécurité

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

4. The green status LeD
completed and the battery pack is
for use.
5. Slide the battery pack
C hecking the battery charge
P ress the test button
condition (see Fig. A).
The battery LeD
15
the remaining charge as follows:
ReD / ORANGe / GReeN = maximum
charge / power
ReD / ORANGe = medium charge/ power
ReD = low charge – recharge battery
A ttaching / Removing the
holding bracket
Note: The retaining bracket
removed with the saw blade installed.
Attaching the holding bracket
(see Fig. B–D):
P ress the release button
S lide the holding bracket over the guides of the
shoe
into the tool.
7
L ock the release button
Removing the holding bracket:
P ress the release
10
bracket
forward and out of the guide.
11
I nstalling / replacing the
saw blade
Always wear safety gloves when installing /chang-
ing the saw blade.
Turn the quick-release chuck
the direction of the arrow and keep it turned.
P ush the selected saw blade all the way into the
quick-action blade clamp
ATTENTION! The teeth on the saw blade
must be facing down!
®
shows charging is
13
ready
3
into the tool.
3
to check the battery
16
indicates the condition and
cannot be installed /
11
.
10
.
10
and pull the holding
all the way in
8
.
8
6
R elease the quick-action blade clamp
must then return to its original position.The saw
blade is now locked.

Start-up

Switching on and off

Switching on:
P ress the switch lock
P ress the ON- / OFF switch
Switching off:
R elease the ON- / OFF switch

Sawing techniques

A) Working without holding bracket
(see Fig. E):
W hen cutting thicker branches or sawing wood,
plastic or materials, work WIThOUT holding
bracket. The piece to be sawed must touch the
shoe. Use a rocking motion when cutting round
pieces.
A1) Flush cuts:
When using flexible saw blades with the respective
length you can cut protruding pieces, e.g. pipes, flush
with the wall.
6
1. Place the saw blade directly against the wall.
Before using / Start-up
, which
8
.
1
.
5
.
5
GB
31

Publicité

Table des Matières
loading

Table des Matières