Safety Notices For Chargers; Working Instructions For Sawing; Original Accessories / Tools; Information About Saw Blades - FLORABEST FAAS 10.8 A1 Instructions D'utilisation Et Consignes De Sécurité

... / Safety notices for chargers / Working instructions for sawing / Before using
Secure the work piece. Use clamps or a
vice to firmly hold the work piece. This results
in a safer grip than with your hand.
Wait for the power tool to stop before
putting it down. The tool being used could
catch, resulting in losing control over the pow-
er tool.
Lock the on/off switch to the off posi-
tion before working on the power tool
(e.g. maintenance, tool change, etc.),
and when transporting or storing. Risk
of injury if the on/off switch is accidentally acti-
vated.
Protect the power tool from heat, e.g.
also from continuous sunlight, fire,
water and moisture. Risk of explosion.
Wear the dust mask when using the tool.
If the mains power cable of this appliance is
damaged, it must be replaced by the manufac-
turer or its service department, or a similarly
qualified person to prevent hazards.
S afety notices for chargers
Persons (including children) who lack the know-
ledge or experience to use the tool or whose
physical, sensory or intellectual capacities are
limited must never be allowed to use the tool
without supervision or instruction by a person
responsible for their safety. Always supervise
children to ensure they do not play with the tool.
The charger is only suitable for
indoor use.

Working instructions for sawing

Check the material you wish to cut for foreign
objects such as nails, screws, etc. and remove
these.
Immediately switch off the tool if the saw blade
is jammed. Spread the previously cut slit with a
suitable tool and remove the sabre saw.
S aw the material with an even feed motion.
40 GB
All manuals and user guides at all-guides.com
You may use any saw blade with
universal shaft. Saw blades in various lengths opti-
mised for any purpose are available from your retailer.
Note: The battery is partly charged at the time of
delivery. Charge the battery before use. Li-Ion bat-
teries can be charged at any time without reducing
the life. Interrupting the charging process does not
damage the rechargeable battery.
1. To remove the battery pack
2. Insert the rechargeable battery pack
3. Insert the mains plug into the mains socket. The
4. The green status LED
5. Slide the battery pack
O riginal accessories / tools
U se only the accessories specified in
the operating instructions. Using tools or
accessories other than those recommended in
the operating instructions could result in injury.

Information about saw blades

Before using

R emoving / charging / inserting
the battery pack
buttons and slide the battery pack
4
of the tool.
the rapid charger .
12
status LED will light up red.
14
shows charging is
13
completed and the battery pack is
for use.
3
C hecking the battery charge
P ress the test button to check the battery
16
condition (see Fig. A).
The battery LED indicates the condition and
15
the remaining charge as follows:
RED / ORANGE / GREEN = maximum
charge / power
RED / ORANGE = medium charge/ power
RED = low charge – recharge battery
1 / " (12.7 mm)
2
press the release
3
out
3
into
3
ready
3
into the tool.
®