Publicité
Tape Selector
Dolby NR
_
Recording procedures
Bias
Equalizer
Turn on the POWER switch
Load a cassette tape.
Push the PAUSE button
Push the REC and " ® " buttons
simultaneously.
The REC
lamp \
will glow to indicate that the tape deck is ready to begin recording.
6. Adjust
the
recording
levels.
Make
adjustments
while
monitoring
through
your amplifier
or with
headphones
plugged
into the tape
deck. (See section on 'Setting the recording level."')
7. Push
the PAUSE
button again to start the tape, and the tape deck
will begin to record.
8. To stop the tape movement
temporarily during recording, push the
PAUSE button
9. When the recording is finished, push the STOP button.
@
Before
recording, it is recommended
to run the tape all the way
through on fast forward and then back to the beginning on rewind.
This will relieve the unit of the extra burden caused by irregulary-
wound tapes.
Microphone recording
When
using a microphone, the dynamic
type or electret types with an
impedance of 2002 to 5k
should be used. In such cases where usage
of microphone cords ranging in lengths beyond 5 meters, a microphone
with a low impedance of (2002 to 1 kM) should be used.
The plugs of the stereo microphone
or 2 microphones (pair) should be
connected to the MIC-LEFT jack and MIC-RIGHT jack.
OO
C=
Publicité
