La Sommeliere CTPNE147E Notice D'utilisation page 31

9. 9. Place the door on the bottom hinge. Make sure the glass door is upright
and closes easily.
10. Place top hinge on opposite side and door, then replace hinge screws
loosely.
. 11. Once the door is installed, adjust the clearances to keep the door
vertical and then finally tighten the top hinge screws.
12. Refit the upper hinge cover.
Note: The door seal may come out of place when changing sides. If you notice any
openings between the seal and the compartment frame when the door is closed,
carefully pull the seal to close these openings. The correct positioning of the seal is
important to guarantee the tightness of your wine cellar.
Install the handle onto the door of wine cellar
The CTPNE147E wine cellar is supplied with a handle.
Install the handle only with a manual screwdriver. Do not use power tools that could
damage the door.
As the cellar door is reversible, the placement of the handle therefore depends on the
desired configuration.
Holes are visible on each side of the door frame to allow placement of the handle on the
right or left side.
When purchasing your cabinet, the handle is delivered in a separated package and a
bag of hardware is also provided.
The hardware bag contains 2 metal screws to fix the handle and 2 screw covers and 2
hole covers for unused screws and holes.
• Place the handle on the desired location, screw it to the door with the 2 metal
screws provided.
• Use the 2 screw covers to hide the handle screws.
30