Publicité
Les langues disponibles
Les langues disponibles
4. Push wire support
24
the bottom of the catcher. This will support the top rail.
See Figure E.
Fig. E
24
Attaching Grass Catcher To Mower (Fig. F)
1. There are 2 sections of formed plastic grooves
front underside of the catcher. Snap the grooved section
over the support tube
the mower. See Figure F.
Fig. F
25
.
2. Adjust the strap
26
to your preferred length and then
attach the hook to the handle crossbar 27 (your crossbar
style may vary). This strap prevents the grass catcher from
dragging on the ground. See Figure G.
Fig. G
foot through the loop sewn into
23
25
between the trailing wheels of
23
27
26
USAGE AND CARE
General Care (Fig. H-J)
Minimum care is required to assure smooth operation of your
mower.
•
To avoid damage to the mower or cutting blades, keep
the area to be mowed free from any debris.
•
We suggest a routine application of oil or lubricant (i.e.
WD-40). This should be applied to all cutting surfaces, the
cutting reel axle shaft and wheels.
Primary Cutting Height Adjustments
These units can be adjusted to offer a cutting height range
from 1" to 3" (2.5cm to 7.5cm) simply by adjusting the cut
height adjustment lever
adjustment must be performed on both sides of the mower.
As you follow the instructions below, refer to Figure
H for more information.
•
To achieve the lowest cutting position, push the cut
at the
height adjustment lever
reel, and set in place. Repeat for both sides.
•
To achieve the highest cutting position, pull the cut
height adjustment lever
the mower reel, and set in place. Repeat for both sides.
Fig. H
7
Secondary Cutting Height Adjustments
This is used to reduce your cutting height below 2" tall.
The wheel/dust cover assembly can be moved to one of
3 positions on the side plate. Keep in mind that the same
adjustment must be performed on both sides of the mower.
As you follow the instructions below, refer to Figure I.
•
Remove the plastic hub cap
and 18" (46cm) reels) by inserting a small flat head
screwdriver into the slot on the hub cap and pop it off
the wheel
•
Remove the axle nut
by holding the axle pin
7
. Keep in mind that the same
7
forward, towards the mower
7
backwards, away from the
15
(only for the 16" (41cm)
16
.
12
on the inside of the mower
13
in place with either a 1/2"
ENGLISH
5
Publicité
