LaMotte TRACER Mode D'emploi page 9

Scroll Stored
Readings
Exit Memory
Retrieval
Clear Stored
Memory
Change
Measurement
Mode
Enter CON/TDS
Ratio
Change CON/TDS
Ratio
Exit CON/TDS
Ratio
Change
Temperature
Units
Override Auto
Power Off
Default Reset
MAINTENANCE
„ Storage
1. Do not touch the inner surfaces of conductivity electrodes. Touching the
surface of the platinized electrodes may damage and reduce the life of the
probe.
2. Store the electrode dry with the cap on.
3. Always rinse the electrode in deionized water between measurements to
avoid cross contamination. Double rinsing is recommended when high
accuracy is required.
„ Battery Replacement
1. Twist off the battery compartment cap.
2. Hold the battery housing in place with one finger. Remove
the battery carrier by pulling on the small tabs.
3. Replace the four CR2032 batteries. Observe
polarity.
4. Replace the battery compartment cap.
On Memory
Recall
On Memory
Recall
On Any
Measure
Mode
On Any
On TDS (ppm
or mg/L)
On TDS (ppm
or mg/L)
On TDS (ppm
or mg/L)
On (off mode) Press and hold CAL button then momentarily
On Any
Off n/a
Momentary press of MODE button Displays last
in first out.
Momentary press of CAL button
Press and hold the ON/OFF button for 4
seconds until "clr" is displayed.
Press and hold MODE button for 2 seconds.
Modes will scroll by until button is released
Press and release the CAL button twice in quick
succession.
Momentary press of MODE button. Each press
increases ratio by 0.1 from 0.4 to 1.0.
Momentary press of CAL button.
press ON/OFF button. Release CAL button
after"Self Cal" is displayed.
Momentarily press CAL button then
simultaneously press and hold CAL and MODE
buttons for 2 seconds until "oFF" is displayed.
Simultaneously press ON/OFF, CAL and MODE
buttons momentarily. "dFlt" will be displayed.
9