Installation; Points To Be Paid Attention To When The Relocation Of The Refrigerator; Electrical Connection; Important - Beko RFNE350L24W Manuel D'utilisation

3

Installation

B
In case the information which are
given in the user manual are not taken
into account, manufacturer will not
assume any liability for this.
3.1. Points to be paid
attention to when
the relocation of
the refrigerator
1. Your refrigerator should be
unplugged.Before transportation of your
refrigerator, it should be emptied and
cleaned.
2. Before it is re-packaged, shelves,
accessories, crisper, etc. inside your
refrigerator should be fixed with
adhesive tape and secured against
impacts. Package should be bound with
a thick tape or sound ropes and the
transportation rules on the package
should be strictly observed.
3. Original packaging and foam
materials should be kept for future
transportations or moving.
Before you start the refrigerator,
Check the following before you start
to use your refrigerator:
1. Attach 2 plastic wedges as
illustrated below. Plastic wedges are
intended to keep the distance which will
ensure the air circulation between your
refrigerator and the wall. (The picture
is drawn up as a representation and it is
not identical with your product.)
2. Clean the interior of the
refrigerator as recommended in the
"Maintenance and cleaning" section.
3. Connect the plug of the
refrigerator to the wall socket. When the
fridge door is opened, fridge internal
lamp will turn on.
4. When the compressor starts to
operate, a sound will be heard. The
liquid and gases sealed within the
refrigeration system may also give rise
to noise, even if the compressor is not
running and this is quite normal.
5. Front edges of the refrigerator
may feel warm. This is normal. These
areas are designed to be warm to avoid
condensation.

3.2. Electrical connection

Connect your product to a grounded
socket which is being protected by a fuse
with the appropriate capacity.

Important:

The connection must be in compliance
with national regulations.
• The power plug must be easily
accessible after installation.
• Electrical safety of your refrigerator
shall be guaranteed only if the earth
system in your house complies with
standards.
• The voltage stated on the label located
at left inner side of your product should
be equal to your network voltage.
• Extension cables and multi plugs must
not be used for connection.
B
A damaged power cable must be
replaced by a qualified electrician.
B
Product must not be operated
before it is repaired! There is the risk of
electric shock!
10 / 23 EN
Refrigerator/User Manual