Publicité
Cleaning
the Shuttle
Race
This area must be kept free of dust, lint and tangled thread.
Clean the shuttle race area every three months.
• Cleaning
the shuttle
area
_ Bobbin case
_2_Levers
_3_Shuttle race cover
,_4_ Shuttle
,_5_ Shuttle race
,_6_ Center pin on the shuttle
1. Raise the needle bar to its highest point, then and
remove the bobbin case _i_,.
2. Push the shuttle race levers ,_2_ aside. Lift out the shuttle
race cover_3_ and take the shuttle _4_ out.
3. Clean the shuttle race _5_ with a lint brush.
4. Put a drop of oil on the center pin of the shuttle _ and
the shuttle race _5_.Do not over oil.
, Replacing
shuttle assernbly
..:2_, Levers
_3_, Shuttle race cover
,4_,Shuttle
.....
.....
\5_,Shuttle race
,%_ Center pin on the shuttle
::::::::::::::::::::::::::::::::::
L7_, Shuttle driver
\89 Pointed hook
,,"9_ ( Oil here)
......
......
7"
1. Turn the handwhee:! Se the shuttle
forms a
half moon on the:i:ft::iae
of the ma: i
2. Hold the shuttle '.,_:_ i
tinter pi_
_d position the
shuttle so it forms a:R i
: i
i_ht side. The
hook _8_ will be on the
..........
3. Put the shuttle race cover _, back into place over the
shuttle assembly.
4. Snap the levers ,,_,_2b_,
back into the original position.
f,;\
\\
J
7O
Publicité
