Beta Motorcycles EVO 4T EUROPA Mode D'emploi page 127

LEGS ASSEMBLY AND PARTS
Apply the legs to the vehicle and tighten
the screws 1 to the torque indicated.
ATTENTION: Tightening of the screws
should be carried out by adjusting the
torque wrench to the stability torque with
repeated tightening until stability torque
has been achieved.
Grease the wheel bolt.
Apply wheel and wheel bolt.
Apply brake caliper, disc cover and fender.
Tighten to the torque indicated.
ATTENTION: Tightening of the
screws should be carried out by
adjusting the torque wrench to the
stability torque with repeated tight-
ening until stability torque has been
achieved.
Place the vehicle on the ground.
Compress and release the fork 3-4 times.
Tighten the wheel bolt and the screws of
the foot.
ATTENTION: Tightening of the
screws should be carried out by
adjusting the torque wrench to the
stability torque with repeated tight-
ening until stability torque has been
achieved.
10Nm
10Nm
50Nm
55
4
1 10Nm
25Nm
GB