Garland BULK 516 E Manuel D'instructions page 39

2. The cable does not have a big enough section
and/or is too long.
ATTENTION: Use cable prolongators with a minimum
section of 1.5 mm 2 and no longer than 25 m and
always completely unrolled.
7. USING THE MACHINE
Only use this machine for those jobs it has been
designed to do. The use of this machine for any other
use is dangerous and could cause damages to you
and/or the machine.
Only cut wood. Do not use the machine for any
other use. For example: do not use the machine to
cut plastic materials, bricks and other construction
materials that are not wooden. The use of the machine
for other uses could cause dangerous situations.
This machine has not been designed to carry out
forestal work. Due to the electric conexion, the end
user does not have sufficient autonomy to guarantee
his/her security.
Do not come near the chain when the machine is
functioning.
If you lose your stability or if you fall, let go of the
accelerator trigger straight away. Do not only rely on
all security measures of the machine.
Do not use this machine if you are tired, ill, or if you
are under the influence of drugs, medicines or alcohol.
Be extremely careful when using the machine after
it has been raining as the floor could be slippery and
you could slip.
Never cut above shoulder level.
Do not use the machine at night, when foggy or with
reduced visibility that does not allow you to see all the
working area clearly.
Lack of rest and fatigue can cause accidents and
damages.
Limit the usage of this machine to stints no longer
than 10 minutes and rest between 10 and 20 minutes
before using again.
Never let the machine out of your eyesight.
Do not allow anybody inside the working area. The
minimum perimeter of the working area is 15 m and
you must consider this a dangerous area.
If you hold the handles of the machine firmly, you will
reduce significantly the risk of kick backs and you will
incrase control of the machine.
Never use the machine when on top of a ladder, in a
tree or in any other unstable surface. Do not use the
chainsaw one handed.
Be careful when cutting small branches. These can
get tangled with the chain and can be propelled
unexpectedly towards you causing probable loss of
equilibrium.
If you cut a branch that is under tension be alert to a
possible rebound of the branch.
Verify the state of the tree prior to cutting to ensure
that dry branches will not fall off on top of you whilst
cutting.
Clean the work area and remove all obstacles that
could produce accidents.
39/148
English