-The luminaire shall be installed by a qualified electrican and wired in
accordance with the latest IEE electrical regulations or the national
requirements.
- The light source of this luminaire is not replaceable; when the light
source reaches its end of life the whole luminaire shall be replaced.
- Luminaire must not be used or stored in corrosive environment
where hazardous materials such as sulphur,chlorine, phthalates,etc,are present.
- Water entering into IP20 luminaire is strictly prohibited. IP20
luminaire is not protected against wet condition, water ingress may
cause electrical failure or unsafe conditions.
- Luminaire is rated at IP40 from the front (part 1) and IP20 for a complete housing
(part 2).
1: Luminaire opening
1
2.2:Suspend Mounted
2x
2x
2
Part 1
Part 2
Plug all BESA holes
in the housing
3x
2x
2x
or
2.1:Surface Mounted
2.3:Mounted on a BESA
2/16
BESA:
3x L1200/ L1500