Chauvet Professional OVATION REVE E-3 IP Guide De Référence Rapide page 4

EN
Mounting
Before mounting this product, read the
mounting clamps can support the weight of the product. For the Chauvet line of mounting clamps, go to:
http://trusst.com/productcategory/truss-clamps/.
Product Mounting Diagram
Mounting clamp
Secure the safety cable
using the passageway on
the top of the product
Adjustable Yoke
The Ovation Rêve E-3 IP comes with an adjustable yoke for mounting in low-clearance areas. To modify the height of the
yoke, do the following:
1. Loosen the bracket adjustment knobs on both sides of the fixture.
2. On each side of the fixture, remove the two screws and loosen the bolt attaching the plate to the mounting
bracket.
3. Using the screw holes as guide, adjust the position of the mounting bracket to achieve the desired height of the yoke.
4. Put the screws back in place, and tighten the bolts and the bracket adjustment knobs.
3
QUICK REFERENCE GUIDE
Safety Notes. Use at least one mounting point per product. Make sure the
Overhead Mounting
3
Safety cable
Mounting bracket
* Lens tubes sold separately
1
2
Ovation Rêve E-3 IP QRG Rev. 2