Sharp PQ321 Serie Mode D'emploi page 8

CAUTION!
• Be sure to turn off the main power switch and disconnect the plug from the power outlet before connecting/disconnecting cables.
Also, read the manual of the equipment to be connected.
• Be careful not to confuse the input terminal with the output terminal when connecting cables. Accidentally reversing cables
connected to the input and output terminals may cause malfunctions and the other problems.
• Do not use any cable that has a damaged or deformed terminal. Using such a cable may cause malfunctions.
• Images may not be displayed properly depending on the computer (video cards), cables, or peripheral devices to be connected.
For power outlet
3 2
NOTE:
• Set the audio input terminal used for each input mode in AUDIO SELECT on the SETUP menu. The factory settings are shown below.
Input mode
DisplayPort
• The cables connected to the terminals on the rear of the monitor can be fastened with the cable clamp.
Attach the cable clamps to the attachment parts on the back of the monitor and the stand, and bind the cables.
Cable
Cable clamp
attachment
Cable clamp
Cable clamp (small)
Cable clamp
attachment
• DisplayPort is a registered trademark of Video Electronics Standards Association.

E
Connections
1
Audio input terminal (Factory setting)
DisplayPort input terminal
Cable
1. Main power switch
2. AC input terminal
3. Power cord (Supplied)
4
4. RS-232C input terminal
5
5. DisplayPort input terminal
6. Audio input terminal
6
7. Headphone terminal
7
Cable clamp (large)
Cable clamp
attachment Cable
Stand