Tekno Point PICCOLO 12 Manuel D'installation page 49

INSTALLATION
8.4 ELECTRICAL CONNECTIONS
1. Open the panel, remove the screw on the cable cover.
2. Thread the power cable on the hole at the back Inner Unity,
and then pull it out from the front.
3. Remove the cable clip, connect the power cord to the terminal
respecting the color; tighten the screw and then secure the cable
with the clip.
4. Place the back cover of the cables and secure it by tightening
the screw.
1. panel
8.5 COVER TUBES
1. Coat the connecting pipes, power cable and drain hose with
tape.
2. reserve a certain length of the exhaust pipe and power cable
for installation. After having them covered for a certain length
separating the discharge tube and the power cable (as shown
in the figure).
gas pipe
insulating
power
supply
screw wiring cover
cables inside
outside power
tube of liquid
condensate
drain
5. Close the panel.
- All connections between Indoor and Outdoor Unit should be
carried out by qualified personnel.
- If the power cord is not long enough, contact the vendor and
request a new one.
- For air conditioners with power via plug, the plug must be
attached after installation.
3. cover them in the same way.
4. The coolant lines (gas / liquid) should be held separately at
the end.
- The power cable and the control wire can not be crossed.
- The drain hose must be covered from the end.
connecting pipe
power cord
49
drainpipe
band
INSTALLATION MANUAL PICCOLO
17