Tekno Point PICCOLO 12 Manuel D'installation page 42

USER GUIDE INDOOR UNIT
3.11 BUTTON SLEEP
Press this button to activate or deactivate the SLEEP mode
operation COOL / HEAT / DRY.
3.12 BUTTON I FEEL
Press this button to activate and deactivate I FEEL and the
corresponding icon will be displayed in the remote control
display. By activating this function the probe temperature will
be that in the remote control, which will send the information
3.13 BUTTON TEMP
By pressing this button, you can vusualizzare in the desired
temperature of the panel display, the measured temperature
Unit Internal and External Unit, according to the circular
pattern shown below:
Nodisplay
3.1 BUTTON CLOCK
To program the zone, press and 0:00 into the remote display
will flash. Press "+" or "-" within 5 seconds to adjust the
hour. Each press of "+" or "-" buttons, the clock increases or
decreases by 1 hour.
Pressing again 0:00 into the remote display will flash. Press
"+" or "-" within 5 seconds. to adjust the minutes. Each press
of the buttons "+" or "-", the clock will increase or decrease
3.15 BUTTON TIMER ON
This button selects the desired start time. After pressing the
icon disappears, "ON" and blink 00:00. Press "+" or "-"
for 5 sec. to select the desired ignition time "TIMER ON".
Each press of the buttons "+" or "-", the clock increases
or decreases by 1 hour. Pressing "TIMER ON" 0:00 in the
remote control display will flash. Press "+" or "-" within 5
seconds to adjust the minutes. Each press of the buttons
"+" or "-", the clock will increase or decrease by 10 minutes.
Pressing "TIMER ON" 0:00 in the remote control display will
10
INSTALLATION MANUAL PICCOLO
- To change the "MODE" the SLEEP mode will be canceled.
- The feature is not available in FAN and AUTO modes.
to the indoor unit. Make sure that the handset is close to the
user, away from sources of heat or cold environments, and is
able to communicate via infrared with the indoor unit.
- "No Display" will display the desired temperature
- displays the temperature measured Inner Unit
- displays the temperature measured by the Unit External
The indication of outside temperature is not available for
all models. In this case the display will indicate the internal
temperature.
by 1 min. Holding down "+" or "-" button, the display values
will change fast.
Once you reach the desired value, press "CLOCK" to confirm,
The icon will stop blinking 00:00.
notes:
The watch adopts 24-hour mode 00-24.
flash. Press "+" or "-" within 5 seconds. to adjust the minutes.
Each press of the buttons "+" or "-", the clock will increase
or decrease by 1 min. Holding down "+" or "-", the display
values will change fast. Press again "TIMER ON" to
confirm. The display will stop flashing. To clear the
programmed start press "TIMER ON".
42