Tekno Point PICCOLO 12 Manuel D'installation page 43

USER GUIDE INDOOR UNIT
3.16 BUTTON TIMER OFF
This button selects the desired sleep time. After pressing
the icon disappears, "OFF" and flashing 00:00. Press
"+" or "-" for 5 sec. to select the desired start time "TIMER
OFF" .For each button press "+" or "-", the clock increases
or decreases by 1 hour. Pressing "TIMER OFF" on display
00:00 in the remote control will flash. Press "+" or "-" within
5 seconds. to adjust the minutes. Each press of the buttons
"+" or "-", the clock will increase or decrease by 10 minutes.
Pressing "TIMER OFF", the display on the remote control
3.1 FEATURES INTRODUCED WITH COMBINATION OF BUTTONS
Children safety
Press "+" and "-" simultaneously to activate and
deactivate the "LOCK" function.
The icon of the remote control will activate or deactivate
accordingly.
minimum temperature settable value
With the machine off press both buttons "TEMP" and
"-". The display will show the minimum temperature set in
cooling mode (default 16 ° C). E 'can set a new value using
the "+" or "-" from 16 ° C to 31 ° C. A further press of the
"TEMP" and "-" shows the machine in stand-by.
3.1 START OF SEASON
1. Make sure the air vents are clear.
2. Check whether the electrical switch, plug and outlet are
in good condition.
3. Check the filter is clean.
4. Check if the drain hose is effective.
5. Disconnect the power supply.
6. Clean filters and panel Indoor Unit.
will flash. Press "+" or "-" within 5 seconds. to adjust the
minutes. Each press of "+" or "-", the clock will increase or
decrease by 1 minute. Holding down "+" or "-", the display
values will change fast. Press again "TIMER OFF" to confirm.
The display will stop flashing. To clear the sleep timer press
"TIMER OFF"
3.1 NOTES FOR DISPOSAL
1. Most of the packaging materials are recyclable. Please
dispose of them in appropriate recycling units.
2. If you want to eliminate the air conditioner, please contact
the manufacturer or a local authority waste management for
proper disposal.
Unit of measure
The unit is off, press the buttons "-" and "MODE" simultaneously
to set the temperature units between ° C and ° F and vice
versa.
minimum temperature settable value
With the machine off press both buttons "TEMP" and "+". The
display will show the minimum set in the cooling temperature
(default 31 ° C). E 'can set a new value using the "+" or "-"
from 16 ° C to 31 ° C. A further press of the "TEMP" and "+"
buttons shows the machine in stand-by.
43
INSTALLATION MANUAL PICCOLO
11