BOMANN DU 7605 G Mode D'emploi page 44

Assembly
WARNING:
 When assembling or inserting the extraction filter
as well as the carbon filter, the appliance must not
be connected to the mains.
 Failure to use the mounting fixtures may lead to a
risk of electric shock.
CAUTION:
 Before mounting, check that the wall has enough
load capacity to bear the cooker hood.
 When drilling the holes in the wall always make
sure that no existing electrical cables or other ob-
jects are damaged.
 Make sure that the ventilation slots are clear of
obstacles and are not covered.
NOTE: Recommendations for preparation work
 When installing, ask another person to assist.
 Wear protective gloves to prevent injuries from
any sharp edges.
Drilling dimensions
Fig. 1
unit mm
A Shaft closure bracket
B Shaft middle bracket
Fig. 2
Fig. 3
Fig. 5
 Determine the position of the cooker hood central-
ly above the cooking area in accordance with the
specified safety distances.
Totally 8x mounting holes with a diameter of approx.
8 mm are necessary for the wall mounting. Insert the
supplied dowels [Fig. 1].
 First, drill the holes for attaching the housing ac-
cording to the enclosed drilling template. Check
the markings with a spirit level!
Turn in the lower screws 2x ST4*30mm for the
-
suspension of the housing (D) so far that they
project approx. 2~4 mm out of the wall.
 Before attaching the housing, insert the non-
return valves by lightly bending them from above
into the connecting piece (extraction duct) [Fig. 2].
44
C Securing housing
D Suspension housing
Fig. 2a
Fig. 4
Fig. 6