Publicité
Les langues disponibles
Les langues disponibles
I
NSTALLATION
INSTALLING MOUNTING BRACKETS
CAUTION: Before drilling, check under
!
vehicle to avoid damage to
brake or fuel lines, etc.
Place the enclosure in the desired mounting
location and position the mounting brackets
approximately 4" from each end. Push the
mounting brackets as close as possible to the
enclosure without moving or lifting it. Carefully
remove the enclosure and secure the brackets
using the supplied screws.
NOTE: Do not mount the enclosure on cardboard
or plastic panels. Doing so may allow the
screws to pull out from the panel due to
road vibration or sudden vehicle stops.
INSTALLING MOUNTING STRAPS
Feed each strap through the pair of mounting
brackets and position the enclosure in place over
the straps. Tighten each strap securely.
NOTE: Be sure the mounting straps are looped through the buckle correctly. Check the
straps regularly to ensure your enclosure is securely mounted in place.
O
PERATION
ADJUSTING GAIN
To adjust the gain setting, turn the amplifier gains all the
way down. Turn the source unit volume up until distortion
is audible and then turn it down a bit until the distortion is
inaudible. This will be about two thirds all the way up on
most source units. Next, turn the amplifier gain setting
until once again distortion is audible and then back it
down until the distortion is inaudible. Rockford Fosgate
source units do not distort, so the volume can be used at
maximum setting.
NOTE: For a more in depth setting procedure, contact
Rockford Technical Support.
ADJUSTING CROSSOVER (Adj. Xover)
Turn the crossover adjustment knob all the way down. With the system playing, turn the
crossover adjustment knob up slowly until the desired crossover point is achieved.
8
Secure Brackets
to Floor Board
Publicité
