Kenmore W11101350A Mode D'emploi page 5

Tools needed for gas installations:
8" (203 mm) or 10"
(254 mm) pipe wrench
Pipe-joint compound
resistant to propane gas
Parts supplied (all models):
Leveling legs (4)
(Length and appearance of legs may vary according to model.)
Parts package is located in dryer drum. Check that all parts
are included.
Parts needed (steam models):
"Y" connector Short inlet hose
Inlet hose
If using a power supply cord:
Use a UL Listed power supply cord kit marked for use with clothes
dryers. The kit should contain:
A UL Listed 30-amp power supply cord, rated 120/240 volt
I
minimum, and have a temperature rating of 140ºF (60ºC)
minimum. The cord should be type SRD or SRDT and be at least
4 ft. (1.22 m) long. The wires that connect to the dryer must end
in ring terminals or spade terminals with upturned ends.
A UL Listed strain relief.
I
8" (203 mm) or 10"
(254 mm) adjustable wrench
(for gas connections)
or
Rubber washer
Parts needed: (Not supplied with dryer)
Check local codes. Check existing electrical supply and venting.
See "Electrical Requirements" and "Venting Requirements" before
purchasing parts.
Mobile home installations require metal exhaust system hardware
available for purchase from the dealer from whom you purchased
your dryer. For further information, call 1-844-553-6667 (U.S.) or
1-800-469-4663 (Canada).
Optional Equipment: (Not supplied with dryer)
Refer to your Use and Care Guide for information about accessories
available for your dryer.
LOCATION REQUIREMENTS
You will need:
A location allowing for proper exhaust installation. See
I
"Venting Requirements."
A separate 15- or 20-amp circuit needed for gas dryers and
I
30-amp circuit needed for electric dryers.
If using power supply cord, a grounded electrical outlet located
I
within 2 ft. (610 mm) of either side of dryer. See "Electrical
Requirements."
Floor must support dryer weight of 200 lbs. (90.7 kg). Also
I
consider weight of companion appliance.
Level floor with maximum slope of 1" (25 mm) under entire
I
dryer. If slope is greater than 1" (25 mm), clothes may not
tumble properly and automatic sensor cycles may not operate
correctly.
For garage installation, place dryer at least 18" (460 mm)
I
above floor.
Steam models only: Cold water faucet located within
I
4 ft. (1.2 m) of the water fill valves, and water pressure of
20-100 psi (137.9-689.6 kPa). You may use your washer's
water supply by purchasing the necessary parts noted in
"Parts needed."
If you live in a hard water area, use of a water softener is
I
recommended to control the buildup of scale through the
water system in the dryer. Over time, the buildup of lime
scale may clog different parts of the water system, which
will reduce product performance. Excessive scale buildup
may lead to the need for certain part replacement or repair.
IMPORTANT: Do not operate, install, or store dryer where it will
be exposed to water, weather, or at temperatures below 45°F
(7°C). Lower temperatures may cause dryer not to shut off at
end of automatic sensor cycles, resulting in longer drying times.
NOTE: No other fuel-burning appliance can be installed in the
same closet as a dryer.
5