Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1.
Raise the head assembly (B) Fig. 19 to 4" (102 mm) on the "Scale and Pointer".
2.
Remove the screws (A) Fig. 19. Pull the chip deflector or dust collection attachment - whichever is installed - (B) straight out.
The knives are sharp. Be careful when removing, handling, or installing knives.
3.
Insert the supplied wrench (C) Fig. 20 into the hex hole. Rotate the cutterhead until the cutterhead lock engages.
4.
Remove the seven screws (E) Fig. 21 and use magnetic end of the wrench to remove the hold-down bar (F).
5.
Place the magnetized end of the wrench (G) Fig. 22 at the center of the knife. Lift the wrench until the blade (H) separates from
the pins. Remove the knife.
6.
Your unit is equipped with double-edged knives. If the second edge of the knife has not been used, rotate the knife 180
degrees and replace on the cutterhead. Replace the knives if both sides have been used.
7.
Attach the hold-down bar that you removed in STEP 4. Tighten all fasteners securely.
8.
Repeat Steps 3 through 7 to replace the other knives.
9.
Reattach the cutterhead guard or dust collection attachment.
Fig. 19
Fig. 21
E
HOW TO ADJUST THE INFEED AND OUTFEED TABLES
Your unit has been factory set to eliminate snipe. If your unit loses its adjustment and causes snipe, you can adjust the infeed and
outfeed tables to minimize this condition.
1.
Place a dime (A) Fig. 22A at each end of the platen (infeed and outfeed).
2.
Place a straight edge (B) across the two dimes. Extend the straight edge past the leading edge of the infeed and trailing edge of
the outfeed tables.
3.
If your tables are properly adjusted, the straight edge will touch both of the dimes and the edges of the tables (Fig. 22C).
4.
If your table needs adjustment, loosen the locknuts (A) Fig. 22B on the table height-adjustment screws (B). Adjust the screws up
or down to achieve the desired table height.
5.
Make sure that both height-adjustment screws contact the bottom of the table after adjustment.
A
Fig. 22A
A
B
D
F
B
C
H
B
A
Fig. 22B
13
Fig. 20
g
Fig. 22C
Fig. 22
Publicité
Table des Matières
Dépannage
