Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
_________________________________________________________________________________________________________
1.
C
ONTENTS
1.
2.
3.
3.1
3.2
4.
5.
6.
6.1
6.2
7.
7.1
7.2
7.3
7.4
7.5
7.6
7.7
7.8
7.9
8.
9.
10.
11.
12.
13.
Congratulations on purchasing your new radio control
system. We are delighted that you have selected the
MULTIPLEX SMART SX M-LINK. You are now the
owner of a superb system for the newcomer to the
hobby of radio-controlled modelling. We hope you
have many hours of fun and success with your new
equipment.
SMART SX
2.
Q
16
1. Unpack the transmitter and receiver
Store the documents safely.
16
2. Insert the batteries
17
It is essential to maintain cor-
17
rect polarity (see adjacent illus-
17
tration). Reversed polarity may
ruin the transmitter and / or the
18
cells.
20
3. Binding
•
20
Preparing the model
When binding is complete, the receiving system
20
immediately starts operating. Secure the model
21
carefully so that no damage can result if the propel-
21
ler should start turning.
21
•
Prepare the transmitter
21
Hold the multi-function
21
button pressed in and
22
switch the transmitter on,
22
then release the button
22
again. The LED flashes
22
at a high rate.
23
•
23
Prepare the receiver
23
Switch the receiver on
23
with the SET button held
24
pressed in; the receiver
24
LED now flashes at a
24
high rate.
24
If binding is successful, both LEDs revert to a slow
25
flashing rate.
25
4. Check the directions of servo rotation
•
26
Model with ID receiver
26
The transmitter emits an audible signal when it de-
26
tects the receiver. No further adjustments are re-
quired.
26
•
Model with normal M-Link receiver (light or teleme-
27
try)
All the control surfaces (servos) must respond to
27
the sticks in the correct direction; check and re-
27
verse the servos if necessary: move the correct
stick to one end-point and hold the multi-function
27
button pressed in for
28
three
servo
and moves to the op-
posite end-point.
5. Carry out a range check
It is important to check radio range before the first
flight: hold the multi-function button pressed in for two
seconds immediately after
switching on, and the LED
glows
transmitter now generates
greatly reduced power, and
emits an audible warning
signal. In this mode the
Page 16
-S
UICK
TART
seconds:
the
now
reverses,
constantly.
The
Publicité
Chapitres
Table des Matières
