Garland STREAM 550 G Manuel D'instructions page 31

4. Rotate following the groove until you reach the
locking position. Once you have done this, you
must tighten screw (a) to fix the blowing tube.
6.3.2. USAGE AS A VACUUM
1. Introduce the curved tube (no.4) into the catcher
and on the extreme point bring the slender part of
the tube out.
2. Insert the tube to the air outlet of the engine as far
as you can.
3. Rotate following the groove until you reach the
locking position.. Once you have done this, you
must tighten screw (a) to fix the tube.
A
31/124
4. Open the ventilator cover by turning the knob.
5. Connect the two aspiration tubes (no 5 and 6).
6. Insert the tube in the air entry and rotate until you
reach the end of the groove.
Note. This machine has a security switch that will stop
the machine from working with the ventilator cover
open and without the aspiration tubes being properly
fitted. Check the security switch is well placed to the
ventilator so that it activates once the aspiration tube
has been put in place as otherwise the machine will
not start.
English
A
knob