EINHELL Bavaria 44.661.20 Mode D'emploi page 8

Anleitung BBS 240-1 SPK 1
GB
Layout (Fig. 1)
1 ON/OFF switch
2 Glass guard
3 Glass guard holder
4 Hood guard
5 Grinding wheel
6 Fixing screw for the workpiece support
7 Workpiece support
8 Grinding belt
9 Tensioning screw for the upper belt pulley
10 Tensioning lever
11 Fixing screws for the side cover
Fitting the glass guard (Fig. 2)
Fit the glass guard to the hood guard as shown in the
picture.
Changing the grinding belt
Undo the three screws (Fig. 1 Item 11) and take off
the side cover.
Slacken the tensioning screw for the upper belt roller
(Fig. 1 Item 9) by several turns.
Press down the tensioning lever (Fig. 1 Item 10) and
pull the grinding belt off the rollers.
Place the new grinding belt in central position on the
lower and upper roller and let go of the tensioning
lever (Fig. 1 Item 10).
Now tighten the tensioning screw (Fig. 1 Item 9) and
fit the side guard.
Maintenance
Important! Pull out the power plug first.
Remove dust and dirt regularly from the
machine. Cleaning is best carried out with a fine
brush or a cloth.
Never use caustic agents to clean plastic parts.
Technical data
Nominal voltage: 230 V~ 50 Hz
Power: 240 W S2 30 min.
Idle speed n o :
Grinding wheel diameter:
Grinding wheel thickness:
8
14.09.2005 9:09 Uhr Seite 8
Grinding wheel hole diameter:
Grinding belt
Sound pressure level LPA:
Sound power level LWA:
Weight:
Ordering replacement parts
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
2800 rpm
150 mm
20 mm
12,7 mm
50 x 686 mm
70,8 dB(A)
83,8 dB(A)
8,3 kg