Ntering A Password To Access To Installation Level "Level 1 - Pfannenberg SMP55 Instructions D'utilisation

English
The information described below are useful for the user staff. The faults that
require the intervention of a refrigeration engineer must be carried out only by
specialized staff. Follow all electrical legislation when working on the unit based on
valid laws of the countries were the unit is placed.
4.4.
1"
To view parameters visible for the given password, open folder PASS (press esc and set together
[esc+set] from the main display and search the folder "PASS" using the up/down keys) and set the
PASS value (27).
In main view, press Prg to access the
programming menu.
4.5.
option)
Instructions are provided below on how to change from Differential to Fix SetPoint function
of SMP55.
Enter to "level 1" with password (see chapter 4.4)
Press the esc and set keys together to open
the parameters menu. This will open the PAr
menu.
The "td y" parameter will be shown on the
device
WARNING: Turn off and then on again whenever you change the configuration parameters
to prevent malfunctioning on configuration and / or ongoing timings.
Note: To change the setpoint please refer to chapter
8
Entering a password to access to Installation level "Level
Setting password
Label PAr appears
Pressing the two keys will open the menu
containing the list of folders. Use the "up" and
"down" keys to scroll the list until you find the
PASS folder.
Changing of Setpoint mode (Differential thermostat
The PAr parameters menu contains all device
parameter folders. Press the set key to view
all folders.
Press the set key to view the value (Off or
On) of the parameter
70040-096_01-B.docx
Press the set key to open the PASS folder.
Enter the password (27) from here, press the set
key and exit. Now open and view parameters to
change a value (see chapter Parameters).
The first folder the controller shows is the
COnF configuration folder. Press one time
to view "Opt"  press the set key again to
modify individual "Opt" parameters.
To disable Differential function and change to
Fix Set Point set to "OFF" the value
To return to Differential SetPoint function set
this value to "ON"
Status / Setpoint menu